This campaign banner was installed in September, 2019 using a typical "four post installation" method.  It was just a matter of days after the banner was initially installed that it was entirely wadded up from fall Colorado winds.  As you can see, not only did the banner blow down but it was shredded and damaged by one of the posts protruding through the banner.  We were contacted urgently Monday morning from a representative helping with this particular campaign.  He asked how quickly we could print a new banner (we didn't print the original banner).  I informed him that we could have a new banner produced the next day and by the way, we have a solution to install the new banner so it would withstand the windy fall season.  He promptly agreed to purchase the new banner and a two section Banner Bar kit.  

The new banner was installed the following day using three new T-posts and two telescoping Banner Bars connected with a "Center T-post Clip".  This configuration held the banner sized at 40" x 192" (3.33' x 16').  

Twenty eight days after the banner was installed on The Banner Bar, it still looked great despite taking the abuse of windy conditions on a regular basis.

The Banner Bar can be configured in three different ways depending on the kit you purchase.

1. The first configuration allows you to display a banner sized between 6' wide and 8' wide.  This configuration requires two T-posts and can display a single sided banner or double sided banner.

2. The second configuration allows you to display two individual banners in a "V" configuration allowing visibility from two directions.  This setup can be useful if you are displaying your banners on a corner or if you need better visibility for two different directions of traffic.  The "V" configuration supports banners sized between 6' and 8' wide and can be setup with a different size on each side if needed.

3. The third configuration allows you to install banners wider than 8' and requires multiple a "mutual T-connector" and two or more Banner Bar kits.  Banners as large as 40" x 240" can be displayed with three Banner Bars connected with Mutual T-Connectors.

Feel free to call or e-mail if you have specific sizing or setup questions.  contact@gobigbanners.com  970-252-1223